Table of Contents
Advertisement
OMAP35x Evaluation Module
•
Standard 14-pin JTAG debug interface
•
Embedded Trace Macrocell (ETM) debug interface
•
Dual general purpose expansion connectors supporting
o
o
o
o
o
•
The OMAP35x EVM is RoHS compliant
1.4
Functional Overview
The OMAP35x EVM is based on TI's OMAP 3530 applications processor. The Micron
memory is interfaced to the OMAP 3530 processor via the Package-On-Package
technology. The Micron PoP memory supports 2Gbit NAND flash and 2 Gbit Mobile
DDR SDRAM. The DDR memory and NAND Flash are connected to SDRAM
controller (SDRC) and General Purpose memory Controller (GPMC) interfaces of
processor respectively.
It is also equipped with a 3.7" TFT LCD module from Sharp. This LCD Module is
interfaced to the Display subsystem (DSS) interface of the processor.
Analog Video outputs of EVM support both Composite TV (CVBS) output and S-
Video output on the main board. The CVBS or S-Video Outputs are available on
respective connector by default.
OMAP35x EVM supports multiple video input options through OMAP3530's camera
port. Any one of the below interface shall be active at a given point of time.
1. S-Video Input, digitized through Video decoder (TVP5146PFP)
2. Composite Video Input through Video decoder (TVP5146PFP)
3. Component Video Input through Video decoder (TVP5146PFP)
4. Camera Interface – 26-Pin camera connector to support
5. Camera Interface – Provision for LI-3M02CM camera module
The EVM has a SD/MMC slot using SD/MMC1 interface on the main board. And the
SD/MMC2 interface is routed to the expansion connector.
The EVM has a 10/100 Mbps Ethernet interface using an external MAC/PHY
controller LAN 9220 which is interfaced to the OMAP3530 via the GPMC interface.
TPS65950 ADC Input channels
12 bit Camera Parallel Interface
UART(3), McBSP(2), SPI(2), SD/MMC(2), I2C(2) Interfaces
DSS(24 bit), GPMC(16-bit) bus
ETM debug interface
Micron Camera Module
Advertisement
Table of Contents
