The pin out for the P16 connector is shown in the figure below.
Pins
Signal
1
USB_VBUS
2
USB_DM
3
USB_DP
4
USB_ID
5-9
USB_SHIELD
3.5.3 DC Power Jack
Connector P19 is a 2.5mm DC input jack for power adaptor input. This
connector brings in +5 volts to the EVM. It has its inner side tied to VCC +5V
through a fuse and the outer side is tied to ground. The figure below shows this
connector as viewed from the card edge.
3.5.4 UART Connector
The P20 and P21 connector is a DB9 -connector that provides a UART interface
to the EVM. This connector interfaces to the MAX 3218 RS-232 line driver and
is located on the bottom side of the board. A view of the connector from the
card edge is shown in the figure below. The signals present on this connector
are defined in the following table.
Figure 19:
USB Connector
Table 19:
USB Connector
Figure 20:
DC Power Jack
52
Hardware User Guide