Battery Input Connector; Processor Module Connector; Figure 23: Omap Processor Module Board-To-Board Connector; Table 22: Battery Terminal Connector - Mistral OMAP35 Series Hardware User's Manual

OMAP35x Evaluation Module

3.5.6 Battery Input Connector

J11 is a battery main input connector that will carry the battery power in the
OMAP EVM board. It is placed on the bottom of the EVM main board. The J11
connector pin descriptions are given below.
Pin No
1
2
3
4
5
6

3.5.7 Processor Module Connector

P8, P12, P13 and P17 board-to-board connector is used to bring out most of
the OMAP processor signals to the main board. OMAP processor module is a
plug-in option module that will plug in to this connector. Refer schematic
section for signal and pin out details for this connector.
Figure 23:
Signal
VBAT IN
NC
CHG TS
HDQ 2V8
ADC IN0
GND
Table 22: Battery Terminal Connector
P17
P13
P8
OMAP Processor Module board-to-board connector
55
P12
Hardware User Guide