Table of Contents
Advertisement
Cleaning Nozzle Tip and Injector Ring
Follow these procedures to properly clean the Freestyle® at McDonald's nozzle tip and injector ring. Always follow McDonald's
sanitation policies, including expectations to wash hands and to use clean water and approved food grade sanitizer.
1
Locate the nozzle tip. Use the
Nozzle Tip Wrench (Coke® part
#161294) and twist nozzle tip
counter-clockwise. Then pull
down to remove.
Scrub the nozzle tip at a
2
45° angle with approved
detergent cleanser using the
blunt end of the Nozzle
Tip & Injector Ring Brush
(Coke part #149326).
3
Rinse nozzle tip in warm,
clean, drinkable water.
4
Place nozzle tip in approved sanitizer solution (Kay-5).
Shake nozzle tip when submerging to remove any air
bubbles and soak the nozzle tip for no more than 5 minutes.
CAUTION: DO NOT SOAK NOZZLE TIP OVERNIGHT!
NOTE:
If using Kay-5, add 1 oz packets to 2.5 gallons of clean, warm water.
5
Scrub underneath the injector ring (area where the nozzle
connects) using the thick bristled nozzle brush at a 45°
angle and a clean sanitized towel. Focus on the small
holes where ingredient comes out. Allow to sit for 2
minutes. Then repeat with clean sanitizing solution.
6
Allow the nozzle tip and injector ring area to "AIR DRY."
Then use the Nozzle Tip Wrench to reinstall nozzle tip
and lock into place turning clockwise.
NOTE:
Take extra care to ensure the nozzle tip is inserted completely
and locked into place. Be sure to clean the Nozzle Tip Wrench and
Brush when completed.
©2020 McDonald's | ©2020 The Coca-Cola Company | Freestyle at McDonald's | User Guide | Confi dential |
Cleaning & Maintenance
15
Advertisement
Table of Contents
