About The Metal Clamp - Canon DR-4580U Instructions Manual

Before you begin

About the metal clamp

To avoid damage during shipping, the optical unit of the scanner is secured with a metal clamp. Before
moving or installing the scanner, you must install the metal clamp in the specified position.
If you fail to install the metal clamp in the specified position when setting up the scanner, a warning
message will be displayed on the LCD and you will not be able to use the scanner.
1
Pull the scanner out 15 cm (6 in.) over
the edge of a desk or worktable as
shown in the illustration.
Caution!
• To prevent the scanner from falling, do not allow the scanner to overhang the edge of the
table by more than 15 cm (6 in.)
• To avoid damaging the scanner, never turn it upside down or lay it on its side.
2
When moving the scanner, install the
metal clamp on the bottom of the
scanner at position
ting up and using the scanner, install
the clamp at position
10
, and when set-
.
15 cm
(6 in.)
No more than 15 cm!
Metal clamp
Screw