Canon DR-4580U Instructions Manual page 24

Setting up the scanner
Number, mode and
default display
19 Load scanning settings
1 9 . L o a d S e t t i n g
D e f a u l t
Note
• When scanning confidential documents, make sure that the number of pages scanned displayed in the LCD matches
the actual number of pages scanned.
• The double-feed detection warning may be set off by thick or creased documents, pages with correction fluid on
them, and document pages with punched holes. When scanning these types of documents, you should set the
sensitivity for double feed detection Low (15).
• Double feed detection may not operate correctly when scanning documents shorter than 210 mm (8.3 in.), i.e. A5
size documents.
• After changing settings 01 to 17, execute "18 Save scanning settings" to save the changes. If the settings are not
saved before the scanner is switched off, all the changes will be cleared and the previous settings will be restored.
22
Loads the scanning settings from Memory 1 or Memory 2.
Default Memory 1
Use the or key to select Memory 1 or Memory 2. The saved settings
for scanning are enabled with the "Save Scanning Settings" execution.
If other settings have been saved in another memory, you can change
the settings easily during scanning.
This setting is not changed even if the power is switched off and on.
If "Default" is selected, all the saved scanning settings will be reset to
their default values.
Content
Memory 2