Canon DR-4580U Instructions Manual page 28

Setting up the scanner
Summary of the Imprinter menu modes and settings
Number, mode and
default display
01 Setting the imprinter data
0 1 . P r e I m p r i n t
02 Setting the imprinter
start position
0 2 . P r e P o s i t i o n
< 0 C h a r >
03 Setting the imprinter Orientation
0 3 . P r e R o t a t e
26
Uses the imprinter to stamp the front sheet of each scanned page
with text you specify.
H o s t
Host
Host:
Count:
Specifies the starting location of the stamp printed by the
imprinter if Count was selected for 01 above.
Press a select arrow key (
the stamp will print. If zero is entered, the stamp prints 10 mm from the
1 0 . 0 m m
top edge of the page.
Example: 2 Letter Text Setting
0 2 . P r e
< 1 C h a r >
The mm setting tells you the approximate distance of the starting posi-
tion from the top of the page.
Enter a text string 0 (10 mm or 0.4 in.) to 72 characters wide (182.8 mm
or 7.2 in.)
Here is an illustration of the example above. The two letters print 14.8
mm (0.6 in.) from the top.
[
[
[
Spaces fill out stamps shorter
than 7 characters.
The count must be printed with 7-digit numbers. Numbers shorter than
7-digits are counted as spaces and not printed.
This sets the orientation of character printing when using the
imprinter.
H o s t
0
90
180
Rotates character string 270 degrees and prints.
270
Content
Count
Prints the text specified with the software application on the
computer.
Prints according to the counter setting for "Select the counter
displayed on LCD". (Counter menu, mode 01)
) to specify the position on the page where
P o s i t i o n
1 2 . 4 m m
Top of the paper
10mm 14.8mm
(0.4in.) (0.6in.)
Top of the printout when
[
[ the imprinter start position
[
is set to 2 characters.
Host 0 90 180
Prints portrait orientation.
Rotates character string 90 degrees and prints.
Print portrait orientation from the end of
the character string.
270
A
B
B
A
:Transfer direction