Klarstein METROBREEZE ROM Manual page 33

• In COOL or HEAT mode, press the SLEEP button on the remote control or the
UP and TIMER buttons on the control panel simultaneously to start the night
mode. If the fan is running at high or medium speed, the speed will be set
to low. After 7 hours, the unit will automatically turn off. To exit night mode,
press the SLEEP button on the remote control again, or the temperature
change button on the control panel.
• Press the SWING button to start the oscillation of the louvers. PRESS the
button again to turn the function back on.
Dehumidification mode
• Press the Mode button in On mode and select Dehumidification
(DEHUMIDIFY). The corresponding indicator light turns on.
• The temperature cannot be set in this mode.
• Press the SWING button to start the swing function.
Fan mode
• Press the FAN key in On mode to start the fan. The corresponding indicator
light turns on.
• Press the SPEED button to select the speed in the following order: high (HIGH)
> medium (MID) > low (LOW). Press and hold the SPEED button for 5 seconds
to start the internal drying function. The upper and lower fans will then run
together. Press the SPEED button again for 5 seconds to turn the function off.
• The temperature cannot be adjusted in this mode.
• Press the SWING key to start the swing function.
Important notes on operation
• When „FL" lights up in the display and the water level light flashes, the
unit stops until you have drained the water. As soon as the water has been
drained, the unit continues automatically.
• In dehumidification and fan mode (including the drying function), you do not
need to use the exhaust hose.
• If the sun shines directly into your room, close the curtains.
EN
33