Resetting The Settings To Their Factory Default Settings; Information; Carbon-Filter Change Indicator; Cleaning Mode - Miele KFN 7734 D Operating Instructions Manual

Selecting additional settings
Resetting the settings to their factory
default settings 
All settings made on the refrigeration
appliance will be reset to the factory de-
fault settings (for settings, see "Guide to
the appliance").
 In Settings mode , use the  or
 sensor control to scroll to the
 symbol.
 Touch OK.
 Use the  sensor control to scroll to
the  symbol.
 Touch OK.
The refrigeration appliance shuts down
and must be switched on again.
Information 
Appliance data (model identifier and
serial number) is shown on the display.
Tip: This data is important when report-
ing an appliance fault to Miele Cus-
tomer Service (see "Customer Ser-
vice").
56
Carbon-filter change indicator 
After inserting the carbon filter (optional
accessory), you must activate the car-
bon-filter change indicator  in Set-
tings mode .
The carbon-filter change indicator 
on the status display will remind you
to replace the carbon filter approx. ev-
ery 6 months (see "Cleaning and care
– Replacing the carbon filters").
Cleaning mode 
Cleaning mode  makes it easier to
clean the refrigerator section (see
"Cleaning and care"). The interior
lighting remains switched on, even
though the refrigerator section is
switched off. The audible signal will
stop and the symbols on the display
will also go out.
If Cleaning mode  is switched on,
this will be indicated on the status dis-
play.
After cleaning, Cleaning mode  must
be switched off. If the appliance door is
closed for more than 10 minutes,
Cleaning mode  switches itself off
automatically.