Adjusting the display brightness
You can adjust the display brightness to
the lighting conditions in the room.
In Settings mode , use the or
sensor to scroll to the symbol.
Touch OK.
Use the and sensors to select
the display brightness you want.
Touch OK.
Switching off Demo mode
Demo mode allows the refrigeration
appliance to be presented in the
showroom without the cooling system
being switched on. Do not activate this
setting for domestic use.
If Demo mode has been switched on
as a default setting, will appear in
the display when the refrigeration
appliance is switched on.
Touch the OK sensor on the control
panel.
Miele
will appear initially in the display,
followed by the start screen.
Touch OK.
In Settings mode , use the or
sensor to scroll to the symbol.
Touch OK.
After Demo mode has been switched
off, the refrigeration appliance shuts
down and must be switched on again.
Selecting further settings
Resetting the settings to their factory
default settings
All settings made on the refrigeration
appliance will be reset to the factory
default settings (for settings, see "Guide
to the appliance").
In Settings mode , use the or
sensor to scroll to the symbol.
Touch OK.
Use the sensor to scroll to the
symbol.
Touch OK.
The refrigeration appliance shuts down
and must be switched on again.
Information
Appliance data (model number and
serial number) is shown in the display.
Keep this appliance data to hand:
- For integrating the refrigeration
appliance into your Wi-Fi network
(see "Selecting further settings –
Miele@home") (depending on model).
- When reporting an appliance fault to
Miele (see "Service").
51