Table of Contents
Advertisement
Switching off Demo mode
Demo mode allows the refrigeration
appliance to be presented in the show-
room without the cooling system being
switched on. Do not activate this setting
for domestic use.
If Demo mode has been switched on
as a default setting, will show on the
status display.
Tap .
Tap .
Swipe left or right until is shown in
the middle.
Tap .
After Demo mode has been switched
off, the refrigeration appliance shuts
down and must be switched on again.
Resetting the settings to their default
settings
All settings made on the refrigeration
appliance will be reset to default set-
tings (for settings; see "Guide to the ap-
pliance").
Tap .
Swipe left or right until is shown in
the middle.
Tap .
will appear on the display.
Touch OK.
The refrigeration appliance shuts down
and must be switched on again.
Selecting additional settings
Information
Appliance data (model identifier and
serial number) is shown on the display.
Keep this appliance data to hand; you
will need it:
- When integrating the refrigeration ap-
pliance into your WiFi network (see
"Selecting additional settings –
Miele@home").
- When reporting an appliance fault to
Miele Customer Service (see "Ser-
vice").
- When retrieving information from the
EPREL database (see "Service").
Carbon-filter change indicator
After inserting the carbon filter (optional
accessory), you must activate the car-
bon-filter change indicator in Set-
tings mode .
The carbon-filter change indicator
on the status display will remind you
to replace the carbon filter approx. ev-
ery 6 months (see "Cleaning and care
– Replacing the carbon filters").
Cleaning mode
Cleaning mode makes it easier to
clean the refrigerator section (see
"Cleaning and care"). The interior
lighting remains switched on, even
though the refrigerator section is
switched off. The audible signal will
stop and the symbols on the display
will also go out.
If Cleaning mode is switched on,
this will be indicated on the status dis-
play.
51
Advertisement
Table of Contents
