Table of Contents
Advertisement
III. Power on BiPAC 4700ZU/ 4700ZUL
Step 1: Assemble M25 cable gland
Step 2: Unscrew the LAN (PoE) port and insert the supplied outdoor Ethernet cable (RJ-45) through
material A-D, and then connect the RJ-45 Ethernet cable into the LAN (PoE) port.
2.1: Insert C at the back end of D
2.2: clip B on C
2.3: keep B close to D
2.4: then tighten A.
Step 3: Insert the other end of outdoor Ethernet cable (RJ-45) to the supplied Gigabit PoE injector
Data+Power port. Connect another Ethernet cable (RJ-45) directly to the Data port and the other end
of cable to a switch or broadband router.
IMPORTANT: It is recommended to put the Gigabit PoE Injector on an UPS or Surge Protector. Use
the supplied grounding wire to ground your BiPAC 4700ZUL ODU is REQUIRED!
12
Advertisement
Table of Contents
