Table of Contents
Advertisement
HOW TO USE / CONNECTING THE UNITS
How can I reset the
parent unit?
INDICATIONS ON THE PARENT UNIT
Question
The battery LED on the
parent unit turns red�
What should I do?
Why does the parent unit
beep?
What does the battery
LED colour (green,
orange, red) or no
burning LED mean for the
status of my battery?
You can reset the parent unit by simultaneously press the "power on/
off button" and the round "navigation down button" at the front of the
parent unit for about 1 second. The parent unit will switch off. In order
to turn the parent unit back on, press the "power on/off button". Specific
user information stored in the memory of the parent unit such as user
mode, brightness settings, volume, lullaby selection, zoom selection and
vibration settings will not be lost�
Answer
The battery power is low� If you do not connect the parent unit to
the mains power when the battery LED has turned red and starts to
make a beeping sound, the unit will stop working after approximately
60 minutes.
Switch to lower brightness and/or volume to save battery consumption
and connect the parent unit to the mains with the power adapter� (see
chapter 'Preparing for use')�
Your baby monitor beeps in a certain way to tell you what the problem is�
1 beep: parent unit is switched off.
1 beep, every 20 seconds for the first 3 minutes, after that, every minute:
parent unit is low in battery�
2 quick beeps every 20 seconds: temperature of the baby room is outside
the range that is defined by the user, temperature icon is shown on
parent unit's screen�
3 quick beeps every 20 seconds: connection between parent and baby
unit is lost, link icon is shown on the parent unit's screen and the link
connection button is red�
When the parent unit is connected to the mains power the color of the
battery light will show:
* Green: battery is full.
* Orange: battery is charging.
When the parent unit is not connected to the mains power the color of
the battery light will show:
* Red: battery is almost empty (<10 %)
* No burning LED: parent unit is not connected to the mains.
- 32 -
Advertisement
Table of Contents
