Operation And Use; Before Testing; Paper Replacement - Magneti Marelli 007950006900 Owner's Manual

OPERATION & USE:
Note: Each time you connect the tester to a battery, the tester will run a quick
cable verification to ensure a proper connection through the output cables to
sensors in the clamp jaws. If the connection checks out OK, the tester will
proceed to the Home Screen. If the connection is poor, the display will show
damage, as you may need to re-connect the clamps to the battery or replace the
cable end.

BEFORE TESTING:

1. Before you test a battery in a vehicle, turn off the ignition, all accessories and
2. Make sure you have put 4 pcs 1.5V batteries into the battery chamber.
3. Make sure the battery terminals are clean. Wire brush them if necessary.
4. Paper load:

PAPER REPLACEMENT:

A. Open the clear cover.
B. Insert replaced paper roll into the paper feeding for auto running the paper into
C. Pull the paper slowly and straightly from the paper roll in the chamber.
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu
loads. Close all the vehicle doors and the trunk lid.
Oxyride batteries are not recommended because of the initial 1.7 Volt output.
AA BATTERIES
Note that nothing will be seen on the display until the tester is
connected to a vehicle battery.
Clamp the black load lead to the vehicle negative battery terminal. Clamp the
red load lead to the vehicle positive battery terminal. Please clamp on the lead
part of the terminal only. Clamping on the iron part of the terminal will lead to
wrong test results.
Open the clear cover. Insert paper to the paper feeding for auto running the
paper into printer
the printer.
eck cable connections for visible signs of
4 pcs 1.5V batteries before starting the test.
4
INSERT OR CHANGE