10.4.3. Blue Convergence Adjustment
1. Push the "MUTE" button twice and change to the Blue Adjustment
of cyan Colour.
2. Repeat the same steps described for the Green Conv.Adj. in 1~16
to perform the Blue Convergence Adjustment.
3. To store the data after the Blue Convergence Adjustment has
been completed, push the "MAIN MENU" button and then push
the "N" button.
4. To switch from the Convergence Adjustment Mode to the Service
Mode, press the Power button and then push the "N" button.
Repeat the same adjustment after inputting the 60Hz (NTSC)
signal.
Fine Convergence Control Chart
57