Table of Contents
Advertisement
2. Turn the Receiver ON apply and view a monoscope pattern.
3. Adjust each lens focus for best focus while viewing each CRT.
4. Cover the Red and Blue CRT, projecting green only.Rotate the
Green lens for best focus around screen center area.
5. Do the same for the Red focus lens while projecting Red only.
6. Repeat for Blue.
7.4. Centering Magnet Adjustment
1. Receive a monoscope pattern.
2. Confirm that Coarse convergence data (Service mode1) for R,G
and B is 0.
3. Set that Fine convergence data (Service mode1) is clear (no
correction).
4. Set that V-Pos data (Service mode1) is [100].
5. Set that H-Pos data (Service mode1) is [55].
6. Set that H-Parallel data (Service mode1) is [8].
Procedure:
1. Cover the Red, Blue CRT lens, projecting Green only.
2. Adjust green centering magnet (DY) if the projected green
horizontal/vertical line does not line up with the screen horizontal/
vertical center line.
3. Cover the Green, Red CRT lens, projecting Blue only.
23
Advertisement
Table of Contents
