Canceling White Balance Auto Bracketing - Canon EOS-1Ds Instruction Manual

Indicator for the standard shot
Bluish (minus) compensation
Reddish (plus) compensation

Canceling White Balance Auto Bracketing

•
White balance auto bracketing cannot be used together with flash, bulb expo-
sures, or auto exposure bracketing (AEB).
•
If C.Fn-12-1 (mirror lockup) is used during white balance auto bracketing, the
bracketed shots will not be taken continuously even if the drive mode is set to
continuous shooting.
If the drive mode is single-frame shooting, press the shutter button once for each of
the three bracketed shots.
•
With C.Fn-09-2/3, you can change the white balance auto bracketing sequence.
(→p.135)
•
With C.Fn-9-1/3, you can prevent the white balance auto bracketing from being
canceled when you change the lens, replace the CF card, replace the battery, or
set the <
•
With C.Fn-01-1, you can still display the viewfinder information during continuous
shooting. (→p.133)
Take the pictures.
3
s
The bracketed shots will be taken in the following
sequence: standard color temperature, bluish
(minus), and reddish (plus). During this sequence,
the next bracketing level is indicated (by blinking) on
the LCD monitor.
•
The current drive mode is used when you take the
bracketed shots. (→p.99)
•
If continuous shooting is used, holding down the
shutter button fully will capture all three bracketed
shots continuously and then the shooting will stop.
•
If the self-timer is also set, all three bracketed shots
will be taken continuously after the self-timer delay
of 2 sec. or 10 sec. elapses.
•
Follow steps
amount to <
and <
•
White balance auto bracketing will also be canceled
automatically after any of the following actions: the
CF card is replaced, the battery is replaced, a bulb
exposure is set, the flash is ready, the <
button is pressed, or the <
<
> switch to < >. (→p.135)
White Balance Auto Bracketing
1 2
and above to set the bracketing
>. Then let go of the <
> buttons.
>.
>
>
> switch is set to
47
2