Removing The Cf Card - Canon EOS-1Ds Instruction Manual

Installing and Removing the CF Card
•
The number of remaining shots depends on how much capacity remains in the
CF card and the ISO speed setting.
•
The file number is displayed in accordance with the file numbering method you
set. (→p.56) If auto reset has been set, the highest file number in the current
folder will be displayed. If continuous numbering has been set, the file number of
the last captured image will be displayed.
C.Fn-08, instead of displaying the number of remaining shots, you can display the
ISO speed. And instead of displaying the file number, you can display the number of
remaining shots.(→p.135)

Removing the CF Card

Access lamp
•
While the access lamp is blinking ("
on the top LCD panel), do not shake or hit the camera, remove battery, or
open the CF card slot cover. Such actions may destroy the image data or
damage the camera.
•
After the picture is taken, menu operations will not work during the processing
and writing to the CF card (access lamp blinks). If you press the <
during this time, "Busy" will be displayed on the LCD monitor.
•
If a CF card is used for the first time or "
panel, see "Formatting a CF Card" on page 126 to format the card.
•
Do not use a low-capacity CF card. If the image file size is large, the CF card may
not be able to save it.
•
A microdrive is a recording medium using a hard disk. It has a large capacity and
the price per megabyte is low. However, compared to a CF card equipped with a
flash memory, it is vulnerable to vibration and physical shock. If you use a
microdrive, be careful not to subject the camera to vibration, shake, or physical
shock while it is recording or displaying images.
28
Before opening the CF card slot cover:
1
•
Set the < > switch to <
•
Make sure "
panel.
•
Make sure the access lamp is off, then open the
cover.
Press the CF card eject button to pop
2
up the CF card, then take out the card.
•
Close the cover.
" is displayed in the viewfinder and
>.
" is not displayed on the top LCD
" is displayed on the top LCD
> button