Benchmark 209CC Owner's Manual page 17

IMPORTANT! NEVER siphon standing
water for the water supply. Use only cold
water (less than 100 °F or 38°C).
CAUTION! Using a One Way Valve
(vacuum breaker or check valve) at
pump inlet could cause pump or inlet
connector damage.
1) There must be at least 10 ft. (3 m)
of unrestricted garden hose between
pressure washer inlet and any device,
such as a vacuum breaker or check
valve.
2) Damage to pressure washer resulting
from failure to follow these instructions
will void warranty.
3) Run water through garden hose for 30 seconds to flush it of debris. Turn off water.
4) Connect garden hose (not to exceed 50 ft. or 15 m. in length) to water inlet. Tighten
by hand.
WARNING! Risk of eye injury!
Spray could splash back or propel objects resulting in serious injury.
• Always wear indirect vented (chemical splash) safety goggles marked to
comply with ANSI Z87.1 when using or in vicinity of the pressure washer.
• NEVER substitute safety glasses or dry-condition goggles for indirect vented safety
goggles.
5) Turn ON the water, point the spray gun in a safe direction, release the grey
trigger lock, then squeeze trigger to purge the pump system of air and impurities.
5049-744
Inspect inlet screen.
Do no use if damaged,
clean if dirty.
16