Advertisement
CONNECTING THE fusionX TO
YOUR COMPUTER
1 - Download the Noztek Controller software from our
website - https://www.noztek.com/software-down-
load/
2 - Connect the fusionX machine to the laptop with a
USB cable.
3 - Once the cable is connected and the controller
software has been opened on the laptop, you can
control the settings from the laptop interface
- To change temperature or the motor settings. enter
the value you want in the relevant field using the
keyboard and then press "Set".
- To activate or deactivate the fanpress the "ON/OFF"
button next to "Fan state".
- To visualize the data on a graph, go to Display >
Display data on graph.
- To export you data just click on "Export data to .csv"
on the bottom right of the window.
For more in depth guidance on the controller soft-
ware, please find the dedicated controller software
manual in the manuals section of our website
CLEANING
Make sure that most of the material has been
extruded from the barrel before cleaaning
Please use the fusionX protective cover provided to
protect the main body of the machine from any
chemicals used in the cleaning process.
The cover has been custom made for the machine,
please place each tab between the cables and
fixtures underneath the barrel and the motor (back
lays down first). Use the velcro to keep the cover
pieces in place.
OPENING THE BARREL
1.
Unscrew the 4 bolts connecting the motor
casing, pull motor casing back or remove.
2.
Unscrew the two front and two rear grub
screws connecting the couplings to the screw and
pull this back until the coupling has disengaged from
the screw spindle.
3.
Remove both thermocouple couplings (one
connected to the nozzle and the other on top of the
block).
4.
Remove the front nozzle and unbolt the front
nozzle bracket (5 x M8 bolts),
5.
Remove the 10 M10 bolts on the top of the
block
6.
Located on the top block are four M5 allen
bolts ('block splitters'). Screw down each corner 5 or
6 turns and continue until the top block splits apart
from the bottom section.
7.
To remove the screw gently lift the front tip
and the screw should come loose from the bottom
barrel block (Depending on the type of material
debris in the barrel a solvent may be required to
assist the removal process).
NOTE - We do not recommend that you remove the
bottom half of the barrel from the base. We advise
that you clean the barrel in situ.
7
Advertisement
