Advertisement
WARRANTY
• Equipment manufactured by Noztek carries the
standard machine tool guarantee of freedom
from defects in workmanship and material for
one year from date of shipment.
• TO INSURE THAT YOUR WARRANTY IS HELD IN
EFFECT, PROPER OPERATION PROCE
MUST BE OBSERVED.
• NOTE: READ THE SAFETY PRECAUTIONS
BEFORE OPERATING THIS MACHINE.
SAFETY
1. Carefully read the instruction manual.
2. Learn the proper, safe use and limitations of
the equipment.
3. DO NOT operate or use this equipment for any
purpose other than its intended use.
4. DO NOT modify this equipment.
5. DO NOT perform adjustments or maintenance
while system is operating or energize
6. DO NOT clean the equipment with flammable
solvents.
7. DO NOT wash down the equipment with water.
This could cause an electrical hazard.
8. DO NOT probe into extruder vent with the
machine running. Never Use a metal probe in
the vent area. The screw may shear the probe,
causing extensive damage to the barrel
and screw. A wooden probe is recommended.
9. DO wear a face shield, insulated gloves when
operating and when in close proximity to
the extruder during operation. These protective
items must also be worn when adjusting
the die, cleaning the screw, etc. The extruder tem-
peratures are extremely hot and failing to
protect yourself may cause serious injury.
10. The feed hopper MUST be installed on the
extruder feed section at all times when in oper
ation
11. NEVER put hands in the feed section or vent to
remove material.
13. DO NOT switch on the motor until the recom-
mended temperature has been reached.
- 1000w rectangular ceramic heater (max tem-
perature 500c)
- DAK Nozzle Band Heater 35D 25L 230-250V
max.210W (max temperature 450c)
- Auto switching 110v/220v Traco power supply
DURES
24V 10 amp
- Precision machined solid stainless steel barrel
- DC motor 17 RPM – 17 Nm torque
- Precision turned bespoke stainless steel mixing
screw
- 7 inch TFT touch screen
- Stainless steel micro hopper (with hopper
weight)
- 1.75mm and 3mm stainless steel nozzles
- 3 sets ( 6 in total) of hardened steel cutting
blades 10mm, 3mm and 1mm
POWER SWITCH AND START UP
To begin, first cuse the power switch on the side
of the machine to power up.
Powering up will take just a few moments, after
which you'll use the touch screen to set all
extruding parameters and set the machine to
begin.
TEMPERATURE SETTINGS
You are able to set two temperatures, the extrud-
ing temperature and the mixing temperataure.
To toggle between °C & °F, tap on °C/°F directly.
4
TECH SPECS
Advertisement
