Table of Contents
Advertisement
EN 12
4.
TPM9.1AL LA
4.3.3
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Unplug all connectors from the PSU.
2. Remove the fixation screw located right side of the mains
inlet connector.
3. Remove the other four fixation screws located at the
corners of the panel.
4. The PSU can be taken out of the set now.
4.3.4
Small Signal Board (SSB)
Refer to
Figure 4-5
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS cable connector that
connects the panel to the SSB [1].
Caution: be careful, as these are very fragile connectors!
2. Release the clamps and unplug all other connectors [2].
3. Remove all the fixation screws from the SSB [3].
4. Take out the SSB with I/O bracket.
5. The SSB can now be shifted away from side connector
cover and lifted from the set.
Refer to
Figure 4-5
2012-Jun-15
Mechanical Instructions
Figure 4-4 Stand removal
for details.
4
4
3
4.3.5
Speakers
1. Gently release the tapes that holds the speaker cables.
2. Unplug the speaker connector from the SSB.
3. Take the speakers out.
When defective, replace both units.
back to
div. table
2 1
2 2
3
3
Figure 4-5 SSB removal
M4 × 18
4
19330_104_120612.eps
120612
3
3
19330_103_120608.eps
120611
Advertisement
Table of Contents
