Programming Sections; Reading And Writing Parameters - PCB Piezotronics IMI SENSORS 686 Series Installation And Operating Manual

Programming Sections

The screen has two sections:

Actual 686 Settings – This section shows the settings currently programed in the sensor.

686 Settings to Write – This section shows the options for programming the sensor.
Figure 36 – Typical Smart Switch Screen After Successful Parameter Read

Reading and Writing Parameters


Reading Parameters - To read the current sensor settings, click the Read Parameters button. This
operation takes approximately 45 seconds to complete.

Transferring Actual Settings to Settings to Write Field - Use the '>>>' button to transfer all Actual Settings
to the Settings to Write fields.

Writing Parameters- Select the appropriate mode and enter any pertinent parameter information. Click the
Set Parameters button. This causes the settings to be sent to the sensor and then read back and
displayed in the Actual 686 Settings.
Figure 37 – Transferring Actual Settings to Settings to Write Field
PAGE 27