Programming Software; Program Installation - PCB Piezotronics IMI SENSORS 686 Series Installation And Operating Manual

Programming Software

The Smart Switch can be user-programmed with the optional Model 600A29 Programming Kit. The kit includes
USB programmer cable/dongle (Model 070A100), software (Model EE225), terminal block/integral cable adapter
(Model 042M17) and magnet clip (Model 080A214). The software can also be downloaded from IMI's website,
www.pcb.com. This software must be installed prior to connecting the Smart Switch to the computer using the
USB programmer cable. The software includes both the drivers and user interface needed for programming the
Smart Switch. During initial installation, you may need administrative rights for the computer in order to install the
drivers. Once installed, administrative rights are not required for use.
Figure 25 – Model 600A29 USB Programmer Kit

Program Installation

Installing the Software and USB Driver: Insert the software CD provided into the CD drive. The software will start
the installation automatically if your PC is set to auto-install applications. If not, browse the CD and click on
Setup.exe to start the installation process. The default installation directory is C:\PCB\EE225. It is recommended
to use the default setting.
The installer will first install the software and then the WinUSB device driver. This device driver is required for the
programmer software to communicate with the 070A100 USB programmer cable included in the programmer kit.
The following screens will be displayed when the installer starts. Click the Next button to proceed from step to
step.
Figure 26 – Install Location Screen
PAGE 22