Switch Removal & Replacement; Ftap-X-2X8 Section Removal - Fluke FTAP-SX50-2X8 Hardware Manual

Switch Removal and Replacement
FTAP-X-2X8 FIBER TAP SECTION REMOVAL
In the unlikely event the FTAP-x-2X8 Fiber Tap requires repair, it may be removed without the need to
remove the rack mounted chassis. The unique design allows for effortless topology upgrades and enables
the active components to be swapped without breaking network links, providing permanent bypass.
Typical removal is described as follows:
Figure 12. FTAP-x-2X8 rear panel thumbscrew locations
IMPORTANT
A warning symbol in the unit indicates that the fluorescent display module relies on a high
voltage 70V DC source. Display module capacitors store energy and require more than one
minute of discharge time to avoid personal injury or equipment damage. Handle the display
module with caution when power is on.
12
Thumbscrews