HP Compaq dx6100 MT Reference Manual page 194

POST Error Messages
Screen Message
163-Time & Date Not
Set
164-Memory Size Error
201-Memory Error
213-Incompatible
memory Module in
memory Socket(s)
X,X,X
214-DIMM
Configuration Warning
219-ECC Memory
Module Detected ECC
Modules not supported
on this platform
C–2
Probable Cause
Invalid time or date in
configuration memory.
RTC (real-time clock)
battery may need to be
replaced.
CMOS jumper may not
be properly installed.
Memory amount has
changed since the last
boot (memory added or
removed).
Memory configuration is
incorrect.
RAM failure.
A memory module in
memory socket identified
in the error message is
missing critical SPD
information, or is
incompatible with the
chipset.
Populated DIMM
configuration is not
optimized.
Recently added memory
module(s) support ECC
memory error correction.
361293-003
Recommended Action
Set the date and time under Control
Panel or in F10 Setup depending on
the operating system.
If the problem persists, replace the RTC
battery.
Check for proper placement of the
CMOS jumper, if applicable.
Press F1 to save the memory changes.
Run Computer Setup (F10 Setup).
Make sure memory module(s) (if any)
are installed properly.
If third party memory has been added,
test using HP-only memory.
Verify proper memory module type.
Run Computer Setup (F10 Setup) or
Windows utilities.
Ensure memory and continuity modules
are installed correctly.
Verify proper memory module type.
Remove and replace memory module(s)
one at a time to isolate faulty module.
Replace the faulty memory module(s).
If error persists after replacing memory
modules, replace the system board.
Verify proper memory module type.
Try another memory socket.
Replace memory with a module
conforming to the SPD standard.
Rearrange the DIMMS so that each
channel has the same amount of
memory.
If additional memory was recently
added, remove it to see if the problem
remains.
Check product documentation for
memory support information.
Service Reference Guide, dx6100