Type 3 Battery Holder - HP Compaq dx6100 MT Reference Manual

6.17.3 Type 3 Battery Holder

1. To release the battery from its holder, press back lever 1 that extends above one edge of the
battery.
2. When the battery pops up, lift it out 2.
3. To insert the new battery, push it down into the holder with the positive side to the left as
shown in the drawing above.
4. Replace the computer access panel
5. Plug in the computer and turn on power.
6. Reset the date and time, your passwords, and any special system setups, using Computer
Setup. Refer to the Computer Setup (F10) Utility Guide.
Service Reference Guide, dx6100
Removal and Replacement Procedures— Microtower (MT) Chassis
(Section 6.3, "Access
361293-002
Panel").
6–35