BMW X5 2018 Owner's Manual page 124

Controls
After a successfully completed Reset, the
wheels on the Control Display are shown in
green and "Tire Pressure Monitor (TPM)
active" is displayed.
You may interrupt this trip at any time. When
you continue the reset resumes automatically.
Messages
General information
A low tire inflation pressure may cause the
DSC Dynamic Stability Control to be switched
on.
Safety information
WARNING
A damaged regular tire with low or miss‐
ing tire inflation pressure impacts handling,
such as steering and braking response. Run-
flat tires can maintain limited stability. There is
a risk of an accident. Do not continue driving if
the vehicle is equipped with normal tires. Fol‐
low the information on run-flat tires and contin‐
ued driving with these tires.◀
If a tire inflation pressure check is
required
Message
A symbol with a Check Control message ap‐
pears on the Control Display.
124
Safety
Online Edition for Part no. 01402983801 - X/17
Symbol Possible cause
The system has detected a wheel
change, but no reset was done.
No reset was performed for the sys‐
tem. The system issues a warning
based on the tire inflation pressures
stored during the last reset.
Inflation was not carried out accord‐
ing to specifications.
The tire inflation pressure has fallen
below the level of the last reset.
Measure
1. Check the tire pressure and correct as
needed.
2. Reset the system.
If the tire inflation pressure is too low
Message
A yellow warning light is illuminated in
the instrument cluster.
In addition, a symbol with a Check Control
message appears on the Control Display.
Symbol Possible cause
There is a tire inflation pressure
loss.
No reset was performed for the sys‐
tem. The system issues a warning
based on the tire inflation pressures
stored during the last reset.
Measure
1. Reduce your speed and drive moderately.
Do not exceed a speed of
80 mph/130 km/h.
2. At the next opportunity, for instance gas
station, check and correct the tire inflation
pressure in all four tires, if necessary.