Silvercrest SDK 2500 C1 Operating Instructions And Safety Instructions page 11

General safety instructions
DANGER: Risk of burns
• Never touch the hotplates (1, 3) either during or immediately
after use
• Clean the hotplate only after it has completely cooled down.
After use, the surface of the hotplates (1, 3) will retain some
residual heat.
DANGER: Risk of electric shock
• If the power cable of this device is damaged, it must be
replaced by the manufacturer, its customer service or a similarly
qualified person, in order to avoid any possible danger.
• Never open the housing of the hotplate as there are no
components inside which require maintenance. Opening the
housing can expose you to the risk of electric shock.
• If you notice any smoke, unusual noises or strange smells,
switch the hotplate off immediately and disconnect the mains
plug from the socket. If this occurs, the hotplate should not be
used before it has been inspected by authorised service
personnel. Never inhale smoke from a possible device fire. If
you do inadvertently inhale smoke, seek medical attention.
Smoke inhalation can be damaging to your health.
• Make sure that the power cable (2) cannot be damaged by
sharp edges or hot spots. After use, always wind the power
cable (2) back around the cable wrap underneath the
hotplate.
• Make sure that the power cable (2) cannot become crushed or
squashed.
SilverCrest SDK 2500 C1
English - 9