Samsung R710 Service Manual page 33

- This Document can not be used without Samsung's authorization -
2. Introduction and Specification
Boot
Boot Device Priority
▷ Sets the priority of the booting devices.
NumLock
▷ The option to determine whether to switch NumLock on or off when booting.
Enable Keypad
▷ The option to determine how to use the keypad of the keyboard.
- If this option is set to [Only By Fn Key], you have to press a numeric key with the Fn key to
enter a number.
- If this option is set to [By NumLock], you can enter a number by just pressing the
corresponding numeric key if NumLock is switched On.
Summary Screen
▷ The option to determine whether to display the system information (CPU, memory, HDD) on the
screen when booting.
Boot-time Diagnostic Screen
▷ The option to determine whether to display the Samsung logo on the screen when booting.
PXE OPROM
▷ The option to determine whether to always initialize PXE Oprom in relation to a network boot.
Since the general user does not use network boot, setting this option to [Only with F12] is
recommended.
Brightness Control Mode
▷ If this option is set to [Auto], the screen brightness automatically changes to Level 1, when
operating on battery power is detected while booting or resuming from S3 status, or when the AC
adapter is removed and the system power changes to battery while using the system.
▷ If this option is set to [User Control], the previous status is always remembered..
Wireless Device Control
▷ If this option is set to [Always On / Off], the Wireless LAN will be turned on / off when system
boot into Windows.
▷ If this option is set to [Last Status], the Wireless LAN will remain its status as the last time when
system in Windows mode.
Smart Battery Calibration
▷ Corrects the difference between the actual battery capacity and the remaining capacity.
2 - 27