Table of Contents
Advertisement
Co m bi n a ti o n W ar m er
Op e r at or ' s Man u a l
▪
Continued from previous page
3.
Remove
the interface panel by pushing the assembly approximately 0.5"
(12.7mm) up, then pull forward at an angle to release the interface bends that
are locked by the tabs.
NOTE:
reduce the strain on the cables.
4.
Secure
the warmer to the wall using the two (2) self-tapping wall screws
(SC-47298)
b
and a #3 Phillips screwdriver.
5.
Re-install
the interface assembly.
bends into place.
MN -4 7 42 4
Re v 1
▪
▪
Make sure to support the interface panel to
b
Make sure
4 / 2 1
▪
I
NSTALLATION
EC-TS-011882
EC-TS-011885
all of the tabs lock the interface
EC-TS-011888
Continued on next page
29
Advertisement
Table of Contents
