I
NSTALLATION
How to Install the Built-In Warmer into the
Wall
Before you begin
Procedure
28
you have:
Make sure
▪
An appropriate lifting device and enough personnel to safely move and position
the weight of the warmer.
▪
#3 Phillips screwdriver.
▪
Supplied (2) SC-47298 wall screws.
To install the built-in warmer into the wall, do the following.
Step
Action
1.
After wiring the warmer,
Open
the warmer door.
2.
Remove
the three (3) screws
NOTE:
install
the warmer into the wall cutout.
a
using a #3 Phillips screwdriver.
Set the screws to the side for re-installation.
a
C om b i n at i on W a rm e r
Op er a to r ' s Ma n u al
▪
EC-TS-011875
EC-TS-011879
Continued on next page
M N- 47 4 2 4
Rev 1
4/ 2 1
▪
▪
▪