Titan TTB602GRD Safety And Operating Manual page 15

5. DISC FITTING
The inner flange is located over the spindle and on the two
spindle flats. Locate the disc onto the inner flange and then
the outer flange screwed onto the spindle. Fit the threaded
outer flange making sure it is facing in the correct direction
for the type of disc fitted. For cutting disc, the flange is fitted
with the raised portion facing away from the disc (Fig. 6b).
For grinding disc, fit the threaded outer flange with the
raised portion facing the disc (Fig. 6a).
Press the spindle lock button (1) and rotate the spindle until
it locks, then firmly tighten the outer flange using the
provided spanner to clamp the disc. The pins on the
spanner locate in the holes on the outer flange (Fig. 7).
Check the disc rotates freely and is securely clamped.
Make no load test run for 20 seconds to check disc
vibration and disc run out. To remove a disc, reverse these
instructions.
Warning: the spindle lock button must only be
used when changing a disc. Never press when the
disc is rotating! Always ensure your disc is securely
clamped.
6. VARIABLE SPEED DIAL
Please always adjust the speed to suit different working
materials. The tool works quicker and smoother at optimum
speeds.
Adjust the dial to increase or decrease the speed. The
speed increases as the numbers on the dial increase.
The setting on the dial equates approximately to no-load
speeds that increase from 3000/min to 12000/min approxi-
mately in 6 steps.
Please refer below table for roughly speed selection base
on materials that will but cut/ grinding:
Working method Working materials
Grinding Steel black
Corrosion-proof steel
Non-ferrous materials
Cutting Concrete/ Stone
Precast concrete block
Brick
Non-ferrous materials
Others synthetic materials
(PVC, PC and so on)
ANGLE GRINDER 1010W TTB602GRD
(Fig. 6 & Fig. 7 & Fig. 8)
(Fig. 9)
Fig. 5
Fig. 6
Number on
Fig. 7
speed dial
6
6
4
6
6
6
3-4
3 Fig. 8
Inner flange
Outer flange
Inner flange
Outer flange
a
b