HP ProCurve 6600-48G-4XG Installation Instructions page 4

Route the power cord through the plenum opening, and up
and over the switch in either a single- or stacked-switch
installation.
Figure 6. Routing a Power Cord Up and Over the Switch
4. Secure the switch to the rack.
Use two 10-32 screws (one for each bracket) to tighten the plenum and mounting bracket (in a
power-side mounting) or only the bracket (in a port-side mounting) to the rack.
Power-side mounting for a 6600 Switch (Option 1 or 2)
Figure 7. Securing the Switch to the Rack
© Copyright 2009 Hewlett-Packard
Development Company, L.P. The
information herein is subject to
change without notice.
4
Install and tighten a 10-32 screw in the
middle hole.
When you mount a pair of 6600 switches so that one is on top of
the other, the opening in the bottom of each plenum allows you
to route the power cord up and through it.
Port-side mounting for a 6600 Switch (Option 3)
Part Number: 5992-5503
June 2009
Printed in China
*5992-5503*