Table Of Contents - Mr. Heater F270800 Operating Instructions And Owner's Manual

NEVER LEA NEVER LEA NEVER
SPECIFICATIONS
MODEL NO. .................................MH125LP
GAS TYPE ........................................LP-Gas
MAX. INLET PRESSURE. ........... 14 IN. W.C.
MIN. INLET PRESSURE .............. 14 IN. W.C.
MANIFOLD PRESSURE .............. 12 IN. W.C.
WARNING
DO NOT EXCEED ½ psi (14" w.c.) GAS
PRESSURE TO THE GAS CONTROL VALVE.
CLEARANCE (Minimum clearances to combustible materials)
Do not exceed the gas supply pressures shown on rating plates. The maximum inlet gas supply pressures and minimum inlet supply pressures
(for purposes of input adjustment) for LP-Gas are shown as follows:
MODEL NO. BTU/HR RATING
TYPE GAS
MH125LP 95,000 - 125,000*
*Tank size and tank temperature can directly affect BTU output
CONTENTS
Installation Instructions ..................................................... 4
Location ............................................................................ 4
Piping ............................................................................... 4
Operating Instructions ...................................................... 5
Lighting and Shut Down ................................................... 5
Maintenance Instructions .................................................. 6
Replacement Parts List ...................................................... 6
Service and Parts Ordering Information ............................. 8
WARNING:
gas appliances, and the products of combustion of such
fuel, can expose you to chemicals including benzene, which
is known to the state of California to cause cancer and
cause birth defects or other reproductive harm, for more
information go to www.P65Warnings.ca.gov
Mr. Heater, Inc. | Portable Propane Radiant Heater
LEAVE THE HEA VE THE VE THE HEA HEATER UNA
NORMAL OPERATING
LP-GAS
Fuels used in liquefied propane
TER TER UNA UNATTENDED WHILE BURNING! TTENDED WHILE BURNING! TTENDED WHILE BURNING!
VENTILATION
WARNING
THIS APPLIANCE IS UNVENTED AND MUST BE
USED ONLY IN A WELL VENTILATED AREA.
The flow of combustion and ventilation air must not be
obstructed. DO NOT use in a tightly enclosed area.
Any combustion process requires and consumes oxygen, and may
produce carbon monoxide. This heater must be operated with
adequate ventilation. Two openings directly to the outdoors must
be provided, one low and one high, preferably on opposite sides
of the area to be heated. Each of these openings must provide
at least three square inches of combustion air-intake area and
exhaust outlet area for every 1000 BTUs per hour of heater input
rate in order to complete the combustion/ventilation process.
Provide additional ventilation for any additional fuel-burning
appliances and/or additional occupants.
POSTION
VERTICAL
FOR YOUR SAFETY
Do not use this heater in a space where
gasoline or other liquids having flammable
vapors are stored or used.
The heater is designed and approved for use as a construction
heater under ANSI Z83.7 / CGA 2.14
We cannot anticipate every use which may be made of our
heaters. CHECK WITH YOUR LOCAL FIRE SAFETY AUTHORITY IF
YOU HAVE QUESTIONS ABOUT APPLICATIONS.
Other standards govern the use of fuel gases and heat producing
products in specific applications. Your local authority can advise
you about these.
This appliance is intended for temporary heating of buildings
under construction, alteration or repair.
WARNING:
YOU TO CHEMICALS INCLUDING LEAD AND LEAD
COMPOUNDS, WHICH ARE KNOWN TO THE STATE
OF CALIFORNIA TO CAUSE CANCER AND BIRTH
DEFECTS OR OTHER REPRODUCTIVE HARM. FOR MORE
INFORMATION VISIT WWW.P65WARNINGS.CA.GOV
Operating Instructions and Owner's Manual
2
CLEARANCES TO
COMBUSTIBLES
TOP SIDES
48" 60"
THIS PRODUCT CAN EXPOSE
BACK
60"