Table of Contents
Advertisement
■ To unsplit the keyboard
1.
Use the bp^ button to cycle through settings
until the "^CTRL" indicator to the right of the
button is lit.
2.
Touch ck SPLIT so the "SP" indicator
disappears from the display.
Configuring Layer and Split Settings
You can individually configure volume level, octave shift, and
tuning settings for the Upper1, Upper2, and Lower parts. You
can also specify whether or not pedal and/or cn PITCH
BEND wheel operations should affect each part.
■ To change the volume level, octave shift, and
tuning settings of each part
Use FUNCTION parameters
OCT SHIFT), and
22
(PART FINE TUNE) to configure each
setting. For information about FUNCTION parameters, see
"Configuring Function Settings (FUNCTION
EN-53).
Use this
Parameter Name
setting
(Displayed)
(displayed):
PART VOLUME
0 - 127
3Upper1 Part,
Upper2 Part,
Lower Part
PART OCT SHIFT
–2 - +2
3Upper1 Part,
Upper2 Part,
Lower Part
PART FINE TUNE
–99 - +99
3Upper1 Part,
Upper2 Part,
Lower Part
14
(PART VOLUME),
18
(PART
Mode)" (page
To do this:
Adjust the volume
level of each part.
Specify the octave
shift amount of each
part.
Specify, in 1-cent
steps, the pitch of
each part.
■ To enable or disable pedal operations and pitch
bend wheel operations for each part
Use FUNCTION parameters
ASGN PEDAL),
48
(PEDAL UNIT), and
configure each setting. For information about FUNCTION
parameters, see
"Configuring Function Settings (FUNCTION
Mode)" (page EN-53).
Use this
Parameter Name
setting
(Displayed)
(displayed):
PEDAL UNIT
On, Off
3Upper1 Part,
Upper2 Part,
Lower Part
DAMPER PEDAL
On, Off
3Upper1 Part,
Upper2 Part,
Lower Part
EXP/ASGN PEDAL
On, Off
3Upper1 Part,
Upper2 Part,
Lower Part
WHEEL
On, Off
3Upper1 Part,
Upper2 Part,
Lower Part
*1 The On/Off setting selected here is applied only while the
"Sustain", "Sostenuto", or "Soft" setting in the table under
"To change the function of the pedal connected to the
DAMPER PEDAL
jack" (page EN-7) is selected. In all
other cases, the effect (or function) assigned to the pedal
is applied, regardless of what is selected here.
*2 The On/Off setting selected here is applied only while the
"Expression", "Sustain", "Sostenuto", or "Soft" setting in the
table under
"To specify the pedal
selected. In all other cases, the effect (or function)
assigned to the pedal is applied, regardless of what is
selected here.
Digital Piano Operations
36
(DAMPER PEDAL),
41
52
(WHEEL) to
To do this:
Specify whether or not
the three pedals
connected to the
cs PEDAL UNIT
jack should be applied
to each part.
Specify whether or not
the pedal connected
to the cr DAMPER
PEDAL jack should
be applied to each
1
part.*
Specify whether or not
the pedal connected
to the
dl EXPRESSION/
ASSIGNABLE jack
should be applied to
2
each part.*
Specify whether or not
the cn PITCH BEND
wheel effect should be
applied to each part.
type" (page EN-9) is
EN-17
(EXP/
Advertisement
Table of Contents
