Casio PX-S3100BK User Manual page 10

■ To specify the pedal type
You can use FUNCTION parameter
select one of the settings below.
Select this
setting
To connect this type of pedal:
(displayed
setting name):
SW Switch type pedal (CASIO sustain
pedal)
Exp.Type1 Polarity Type 1 (see the illustration
below) expression pedal
Exp.Type2 Polarity Type 2 (see the illustration
below) expression pedal
• Note that the expression pedal polarity type depends on the
manufacturer. When connecting an expression pedal,
select "Exp.Type1" or "Exp.Type2" in accordance with its
polarity type.
• For information about FUNCTION parameters, see
"Configuring Function Settings (FUNCTION
EN-53).
42 ("Pedal Type") to
Mode)" (page
■ To specify the pedal function
You can use FUNCTION parameter
select one of the settings below. The settings from
"Expression" to "Layer Balance" are expression pedal
settings, while the settings from "Sustain" to "Fill-in" are switch
type (CASIO sustain) pedal settings.
Select this
setting
To assign this function to the pedal:
(displayed
setting name):
Expression Expression (MIDI Control Change 11)
control
Master Volume Overall Digital Piano volume level
control
Tempo Tempo control
Layer Balance Upper1 part and Upper2 part volume
level balance control
Sustain
Sostenuto
Same as "Sustain" to "Fill-in" under
Soft
change the function of the pedal
connected to the DAMPER PEDAL
Arpeggio Hold
jack" (page EN-7).
Play/Stop
Fill-in
• For information about FUNCTION parameters, see
"Configuring Function Settings (FUNCTION
EN-53).
■ Expression Pedal Calibration
When connecting an expression pedal to the
dl EXPRESSION/ASSIGNABLE jack for the first time,
perform the calibration operation below.
1.
Connect an expression pedal to the
dl EXPRESSION/ASSIGNABLE jack.
2.
Hold down the bp^ button until "[FUNCTION]"
appears on the display.
This enters the FUNCTION Mode.
3.
Use the bk U and bl I buttons to display
"PEDAL/WHEEL" and then touch bm ENTER.
4.
Use the bk U and bl I buttons to display
"EXP/ASGN PEDAL" and then touch
bm ENTER.
5.
Use the bk U and bl I buttons to display
"Exp Calibration" and then touch bm ENTER.
This displays "Sure?". If you want to cancel the operation
at this point, touch bk – here.
Overview and Setup
43 ("Pedal Target") to
"To
Mode)" (page
EN-9