To Modify Split Settings - Casio Celviano AP-710 User Manual

Playing with Different Tones
5.
Select the tone for the right side range.
• Use the clw and q arrow buttons to select "U1"
and then press the cmENTER button.
6.
Select a tone and then press the cmENTER
button.
• If you want to use layering for the right keyboard
(page EN-16), repeat steps 5 and 6 to select the "U2"
(Upper 2) tone.
7.
Press a keyboard key.
• This will sound the tones assigned to the left and
right side ranges of the keyboard.
8.
To cancel the split keyboard and switch to a
single tone (Upper 1), press the cnLAYER
button or ckEXIT button.
• Each press of the cnLAYER button toggles between
unlayered (one tone) and layered (two tones).
• Two tone output is enabled while the cnLAYER
button lamp is lit.
EN-18

To modify split settings

1.
Hold down the cnLAYER button until the
screen shown below appears.
2.
Use the clw and q arrow buttons to
select an item.
Display
Description
Name
Lower Lower Octave. Changes the octave
Octave of the left (Lower) side of a split
keyboard in one-octave units.
A value that is 1 or higher raises
by the specified number of
octaves, while a value that is –1 or
lower lowers by the specified
number of octaves.
Lower Lower Volume. Adjusts the
Volume volume level of the left (Lower)
side of a split keyboard.
Split Split Point. Specifies the left/right
Point keyboard split point. The initial
default split point is F#3.
Lower Lower Pedal. Enables (On) or
Pedal disables (Off) damper pedal
operation for the tone of the left
(Lower) side of a split keyboard.
3.
Use the clu (–) and i (+) arrow buttons to
change the setting.
4.
To return to the screen you were at prior to
step 1 of this procedure, press ckEXIT
button.
Setting
Range
–2 to +2
0 to 127
A0 to C8
On
(Enabled),
Off
(Disabled)