Starting A Cycle Wash; Changing The Program Mid-Cycle - Midea WQP6-3602F Instruction Manual

Description
Program
Of Cycle
Wash(70℃)
Rinse
Rinse(65℃)
Salf-cleaning
Drying
NOTE:
This program is the test cycle. The information for comparability test in
EN 50242: accordance with EN 50242.

Starting A Cycle Wash

1. Draw out the basket, load the dishes and push it back.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page "Product
specification".
4. Close the door, press the Power button, to switch on the machine.
5. Choose a program, the response light will turn on. Then press the Start/Pause
button, the dishwasher will start its cycle.

Changing The Program Mid-cycle

A wash cycle can only be changed if it has been running for a short time otherwise,
the detergent may have already been released and the dishwasher may have already
drained the wash water. If this is the case, the dishwasher needs to be reset and the
detergent dispenser must be refilled.
To reset the dishwasher, follow the instructions below:
1. Press the Start/Pause button to pause the washing.
2. Press Program button for more than 3 seconds - the program will cancel.
3. Press the Program button to select the desired program.
4. Press the Start/Pause button, after 10 seconds, the dishwasher will start.
Detergent
Pre/Main
15g
(Or 3 in 1)
Make sure that the water supply is turned on to full pressure.
3 sec
Running
Time(min)
80
14
Energy Water
(Kwh) (L)
0.58 6.6
Rinse
Aid