Starting A Cycle Wash; Changing The Program Once Started - Midea UP2-HK Instruction Manual

Starting A Cycle Wash

1. Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to ”
on page32. Make sure that the water supply is turned on to full pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Choose a program, the response light will turn on. Then press the Start/Pause
button, the dishwasher will start its cycle.

Changing The Program Once Started

A wash cycle can only be changed if it has been running for a short time otherwise,
the detergent may have already drained the wash water. If this is the case, the
dishwasher needs to be reset and the detergent dispenser must be refilled. To reset
the dishwasher, follow the instructions below:
1. Press the Start/Pause button to pause the washing.
2. Press the running program button for more than 3 seconds, the program will be
cancelled.
3. Press the the desired program.
4. Press the Start/Pause button, the dishwasher will start.
20
About Power Connection
”