Table of Contents
Advertisement
Super IO Configuration
This section is used to configure the I/O functions supported by the onboard Super I/O chip.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
Super IO Confi guration
NCT6102D
Super IO Chip
Restore AC Power Loss
[Power Off]
[Second]
WatchDog Timer Unit
0
Super IO Watchdog Timer
Serial Port 1 Confi guration
Serial Port 2 Confi guration
Serial Port 3 Confi guration
Serial Port 4 Confi guration
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Restore AC Power Loss
Power Off
When power returns after an AC power failure, the system's power is off. You
press the Power button to power-on the system.
Power On
When power returns after an AC power failure, the system will automatically power-on.
Last State
When power returns after an AC power failure, the system will return to the state
where you left off before power failure occurs. If the system's power is off when AC
power failure occurs, it will remain off when power returns. If the system's power is on
when AC power failure occurs, the system will power-on when power returns.
Watchdog Timer Unit
Selects the watchdog timer unit: second or minute.
Super IO Watchdog Timer
Sets the timeout value of the super IO watchdog timer. 0 means disabled.
Chapter 3 BIOS Setup
Chapter 3
Restore AC Power Loss
Help.
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save & Reset
ESC: Exit
must
34
Serial Port 1 Configuration to Serial Port 4 Configuration
Sets the parameters of serial port 1 (COM A) to serial port 4 (COM D).
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
Serial Port 1 Confi guration
Serial Port
[Enabled]
Device Settings
IO=3F8h; IRQ=4;
Change Settings
[Auto]
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
Serial Port 2 Confi guration
Serial Port
[Enabled]
Device Settings
IO=2F8h; IRQ=3;
[Auto]
Change Settings
RS485 Auto Flow
[Enabled]
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Enable or Disable Serial
Port (COM)
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save & Reset
ESC: Exit
Enable or Disable Serial
Port (COM)
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save & Reset
ESC: Exit
www.dfi .com
Advertisement
Table of Contents
