Table of Contents
Advertisement
8. Using a flat screwdriver, set one of the following taps with the power selector on
the front of the speaker:
Tap #1
Tap #2
Tap #3
Tap #4
Tap #5
Tap #6
9. Test the operation by powering up the sound system.
10. Finally, install the grill on the speaker frame and turn it slightly so that the
revolving fasteners of the frame and the grille are fitted together. During
assembly, hold the grate by the edges (not the perforated, centre part) to avoid
damaging it. The installation must guarantee compliance with section 5.18
(IP21C) of the EN54 standard: 24.
NOTE:
impedance and power values indicated are exposed according the EN54
standard. However, IC6CLASS-54 can be considered as a 16 Ω and 75WRMS
loudspeaker in use when connected to low impedance lines.
7. PAINT
IC6CLASS-54 is ready to be painted and thus can match any cosmetic criteria of the
environment in which it is installed.
Once the installation is complete, the front grill is the only visible part of the unit, simply
paint it to get the desired result. Paint it carefully, avoiding excess paint from clogging
the small holes in its central area.
Connection to a 70V line
1,5 W
3,7 W
7,5 W
10 W
15 W
7
12Ω - 30W
Connection to a 100V line
3 W
7,5 W
15 W
20 W
30 W
Advertisement
Table of Contents
