Advertisement
PARTS LIST
FIGURE 1
Front Assembly
Rear Assembly
Boom Brace
Mast Clamp
ASSEMBLY
STEP 1 - Contents of Package
A. Remove all parts from the box and compare to parts list
to ensure nothing is missing and to become familiar with
the part names. See figure1.
STEP 2 - Front Section
A. Stand front section up vertically and unfold all elements
(in any order) until they snap into place.
B. Remove bolt, hex nut, and director element from the
front section boom. See figure 2.
C. Unfold the UHF directors. See figure 2.
D. Set front section aside being careful not to bend
the elements (laying it flat on the ground is the
best position).
FIGURE 2 - Front Assembly
UHF Director,
(Unfolded)
UHF Directors
Director Element
Mast Clamp
NOTE: Unfolding elements procedure is the same for both
HD7698
STEP 3 - Rear Section
A. Stand rear section up vertically with cartridge housing up
B. Alternately unfold elements per figure 3 in direction
C. Spin the rear section around so the cartridge housing is
FIGURE 3 - Rear Assembly
UHF Directors
Corner Reflector Assembly (2)
Cartridge
Boot
Housing
HD8200 antennas.
&
and facing away from you.
of arrows until they lock into place in the black plastic
blocks.
now facing you. Unfold the remaining elements in the
same order. See figure 3 for completely unfolded rear
section.
8 Up
7 Down, Over & Up
6 Up
4 Up, Over
Down
&
2 Up, Over
Down
&
TOOLS REQUIRED
(not included)
Flat Head Screwdriver
Phillips Screwdriver
Crescent Wrench or Pliers
Cartridge Housing
5 Down
3 Down
1 Down
Advertisement
