Table of Contents
Advertisement
If you wish to trigger the intermediate position for different
receivers simultaneously, these receivers must be program-
med on the same channel.
3.5.8 Deleting the intermediate position
1. Press the [Pos ▼] button for more than 5 seconds or the
[reset] button.
The intermediate position is now deleted.
The LED flashes green three times.
You can also delete the intermediate position with a pro-
grammed hand-held transmitter.
3.5.9 Deleting the Ventilation position / Turn position /
Fabric stretching position
1. Press the [Pos ▲] button for more than 5 seconds or
the [reset] button.
The ventilation position / turn position / fabric stretching
position is now deleted.
The LED flashes green three times.
You can also delete the ventilation position / turn position /
fabric stretching position with a programmed hand-held
transmitter.
4
Technical specifications
All the information in this chapter refers to an ambient tem-
perature of 20 °C (± 5 °C).
Technical specifications VarioTec-868 (-915)
Power supply
Power supply to the control
unit via power supply unit
Rated surge voltage
Switching current
Ⓒ elero GmbH
22 | EN
230 V / 50 Hz
5 V DC
max. 0.5 A
4 kV
5 A / 250 V AC
at cos φ = 1
Technical specifications VarioTec-868 (-915)
Realized limit ELV
Switching contact at contact
output
Power consumption/standby 0.5 W (typical)
Operation effect
Degree of pollution
Ingress protection
Protection class (control
unit) with proper installation
Ambient temperature [°C]
Radio frequency [MHz]
(band)
Mounting type
Weight [g]
Dimensions (WxHxD) [mm]
Maximum number
of transmitters
Article number (868)
(-915)
Fig. 6 Technical Specifications VarioTec-868 (-915)
Ⓒ elero GmbH
SELV: 8 V
at the terminals 1 to 6
Potential free, can turn
SELV or any outer
conductor
Type 1B
2
IP20
II
0 ... 45
868 | 915
Flush mount housing dia.
58 mm wall installation
surface-mounted in corres-
ponding AP housing
140
85 x 85 x 53
16
28 340.0006 / 28 341.0006
28 340.0906 / 28 341.0906
EN | 23
Advertisement
Table of Contents
