Configuration Commands; Miscellaneous Commands - Matrix Switch Corporation MSC-DE3232 Product Manual

2ru 32 input 32 output aes audio router
Table of Contents

Advertisement

S
[1]
SrcNames
[Src][Lvl][Label]
SysType
W
[Preset]
X
[Dest][Src][Lvl]

3.9 Configuration Commands

Commands in this section are for system configuration and are not considered to be a core part of the MASCOT
protocol. There may be implementation and support variations between different system types. Many of these
commands have been superseded by
Command
Arguments
DHCP
[0 | 1]
FrameIP
[IP]
Gateway
[IP]
IP
[IP]
MAC
MapDest
[Dest][Dest][Lvl]
MapSrc
[Src][Src][Lvl]
MtxGroup
[Number][Number]
NetMask
[Netmask]
PairIO
[0 | 1]
PanelCmd
[Button][Cmd]
PanelCmdEn
[0 | 1]
PanelCond
[Button][Cond]
PanelDis
[0 | 1]
PanelExtEn
[0 | 1]
PanelOfs
[Dest][Src][Lvl][Lvl]
PanelRate
[Number]
SerBaud
[Number]
SysName
[String]
Vars
WebPass
(String)

3.10 Miscellaneous Commands

These additional commands consist of those which are not commonly used, not considered to be a core part of
the MASCOT protocol, and support is most likely to vary between system types and firmware versions.
Command
Arguments
B
(0 | 1)
C
LockStatus
Page 25 of 60
MSC-DE3232 Product Manual
Matrix routing status.
Source names command.
System hardware series.
Store current matrix routing to a preset.
Perform a matrix connect operation.
System Parameters
Description
DHCP enable.
Remote router IP address the panel will control.
Network gateway IP address.
System IP address.
MAC address.
Matrix destination remap command.
Matrix source remap command.
I/O grouping command.
Network mask.
I/O pairing enable. Superseded by the MtxGroup command.
Panel button/GPIO command macros.
Enable panel button/GPIO command macros.
Panel button/GPIO status conditions.
Internal panel button interface disable.
External panel interface enable (if available).
Button panel destination/source offsets and levels to control.
Remote panel refresh rate.
Query or assign serial baud rate.
System name.
Query all system configuration variables.
Assign web password.
Description
Reboot system into Bootloader, typically used for software update. A 0 or 1
value is required and selects the Bootloader IP address. A value of 0 uses
192.168.2.59 and 1 uses configured system IP.
Query system matrix info, which is displayed in the format
DESTS,SRCS,LEVELS,FLAGS1,FLAGS2.
Superseded by the MtxCfg command.
Get video lock status and rate detection information (not all HD router
© 2013-2019 Matrix Switch Corporation
in Mascot protocol version 3.0.
www.matrixswitch corp.com

Advertisement

Table of Contents
loading

Table of Contents