Calibration Ranges - Ambient Weather WS-2902B User Manual

Command
TEMP. and Enter Calibration
MAX/MIN Mode, Indoor
+ 5 seconds Temperature
[SET] Indoor Humidity
[SET] Outdoor Temperature
[SET] Outdoor Humidity
[SET] Absolute Pressure
[SET] Wind Direction
[SET] Wind Speed Factor
[SET] Rain Factor
[SET]* Daily Rain
[SET]* Monthly Rain
[SET]* Yearly Rain
[SET]* Total Rain
[SET] Exit calibration mode
* Not available in earlier models

6.10.2 Calibration Ranges

The following table summarizes the permissible calibration ranges.
Version 2.0 ©Copyright 2020, Ambient LLC. All Rights Reserved.
Mode
Press [WIND +] or [PRESSURE -] to adjust the indoor
temperature up or down.
To restore to factory default, press [ALARM].
Press [WIND +] or [PRESSURE -] to adjust the indoor
humidity up or down.
To restore to factory default, press [ALARM].
Press [WIND +] or [PRESSURE -] to adjust the outdoor
temperature up or down.
To restore to factory default, press [ALARM].
Press [WIND +] or [PRESSURE -] to adjust the outdoor
humidity up or down.
To restore to factory default, press [ALARM].
Press [WIND +] or [PRESSURE -] to adjust the absolute
pressure up or down.
To restore to factory default, press [ALARM].
Note: The absolute pressure calibration affects the
relative pressure by the same amount. It is recommend
you calibrate the relative pressure only, per Section 6.3.
Press [WIND +] or [PRESSURE -] to adjust the wind
direction up or down.
To restore to factory default, press [ALARM].
Press [WIND +] or [PRESSURE -] to adjust the wind
speed factor up or down.
To restore to factory default, press [ALARM].
Press [WIND +] or [PRESSURE -] to adjust the rain
factor up or down.
To restore to factory default, press [ALARM].
Press [WIND +] or [PRESSURE -] to adjust the daily
rain up or down.
Press [WIND +] or [PRESSURE -] to adjust the monthly
rain up or down.
Press [WIND +] or [PRESSURE -] to adjust the yearly
rain up or down.
Press [WIND +] or [PRESSURE -] to adjust the total
rain up or down.
Figure 27
Settings
Page 32