Electronic Function; Electric Brake - Makita TW008GM201 Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Changing the application mode

This tool employs several easy-to-use application modes for driving bolts with good control.

The type of the application mode changes every time you press the button

You can change the application mode within approximately one minute after releasing the switch trigger.

NOTE: You can extend the time to change the application mode approximately one minute if you press the but-

ton

► Fig.8

Application mode

(Assist type displayed on panel)

Bolt mode

Bolt mode (1)

Bolt mode (2)

Bolt mode (3)

: The lamp is on.

NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button

NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The type of the

application mode can be checked by pulling the switch trigger to the extent that the tool does not operate.

Full speed mode

► Fig.9: 1. Button

When full speed mode is turned on, the tool speed

becomes fastest even if you do not pull the switch trig-

ger fully. When full speed mode is turned off, the tool

speed increases as you increase the pressure on the

switch trigger.

To turn on full speed mode, press and hold the but-

ton

. To turn off full speed mode, press and hold the

button

again.

The lamp turns on while full speed mode is on.

NOTE: Full speed mode continues even after switch-

ing the impact force mode/auto stop mode.

Clockwise

This mode helps to repeat screwdriving continuously with

equal torque. This mode also helps to reduce the risk of

breakage of bolts/nuts due to overtightening.

Counterclockwise

This mode helps to prevent a bolt from falling off. When

loosening a bolt with the tool driving in counterclockwise

rotation, the tool automatically stops or slows down after

the bolt/nut gets enough loosened.

NOTE:

The timing to stop the driving varies depending on the

type of the bolt/nut and material to be driven. Make a

test driving before using this mode.

Clockwise

The tool stops automatically as soon as it has started

impact blows.

Counterclockwise

The impact force is 4. The tool stops automatically as soon

as it has stopped impact blows.

Clockwise

The tool stops automatically approximately 0.5 second

later from the moment that the tool has started impact

blows.

Counterclockwise

The impact force is 4. The tool stops automatically approx-

imately 0.2 second later from the moment that the tool has

stopped impact blows.

Clockwise

The tool stops automatically approximately 1 second later

from the moment that the tool has started impact blows.

Counterclockwise

The tool slows down the rotation after it has stopped

impact blows.

2. Lamp

Feature