Installing The Thermostat - Frico PLTB16R Manual

Installing the thermostat

Important the thermostat must not be
installed where it may be exposed to
the following:
• direct sunlight and draughts.
• extreme fluctuations in temperature
or high air humidity.
The floor sensor should be mounted in a
spiral hose laid in the floor. The hose en-
dings should be sealed so that the floor
sensor can easily be replaced. All tubes
leading into the appliance box must be
sealed so that the air temperature sensor
cannot be affected by draughts.
Installation
Mount the thermostat in a 65 mm
standard appliance box.
1. Make sure the box is level with the wall.
2. Take off the front and frame by pres-
sing in the latch on the right-hand side
with a screwdriver or similar tool, as
shown in the illustration.
3. Connect power, voltage 230 VAC,
load and any floor sensor cable. Any
extension to the floor sensor cable
must be by means of high-voltage cur-
rent. Protective conductors for the
30