Table of Contents
Advertisement
Removing the door cover
The oven door cover can become discoloured. To carry out
thorough cleaning, you can remove the cover.
Open the oven door fully.
1.
Unscrew the oven door cover. To do this, undo the left and
2.
right screws (figure A).
Remove the cover (figure B).
3.
$
Make sure that the oven door is not closed while the cover is
removed. The inner panel may be damaged.
Clean the cover with a stainless-steel cleaning agent.
Replace the cover and secure it in position.
4.
Close the oven door.
5.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
Detach the oven door and lay it on a cloth with the handle
1.
facing down.
Unscrew the cover at the top of the oven door. To do this,
2.
undo the left and right screws (fig. A).
Lift the top panel up and out (fig. B).
3.
$
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Problem
The appliance does not work.
The text "Time 00:00" appears in the dis-
play. The time is not the current time.
18
%
%
Possible cause
Faulty circuit breaker
Power cut
Unscrew the retaining clips on the right and left. Lift the panel
4.
and remove the brackets from the panel (fig. C). Take out the
panel.
&
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left.
Insert the panel diagonally towards the back (fig. A).
1.
Stick the retaining clips onto the right and left-hand sides of
2.
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. B).
$
Insert the uppermost panel diagonally towards the back. The
3.
smooth surface must face outwards.
Put the cover back in place and screw it on.
4.
Attach the oven door.
5.
Do not use the oven again until the panels have been
correctly fitted.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Note/remedy
Look in the fuse box and check that the circuit
breaker is in working order.
Reset the current time and press the
%
button.
0
Advertisement
Table of Contents
