Table of Contents
Advertisement
Use the hook to attach the rear holder into the upper
3.
hole ‚ and push it into the lower hole ƒ (fig.
Attaching the rails
When hanging the rails, ensure that the sloping edge is
at the top of the rail.
The rails only fit on the right or the left side. The pull-out
rails must pull out forwards.
Mount the rear of the frame at the top and bottom ‚
1.
and pull it forwards ƒ (fig.
Then insert it at the front ‚ and push it down ƒ
2.
(fig.
).
"
).
#
).
!
qAppliance door
W ith good care and cleaning, your appliance will retain
A p p l i a n c e d o o r
its appearance and remain fully functional for a long
time to come. This will tell you how to clean the
appliance door.
Removing the door cover
The stainless-steel inlay in the door cover may become
discoloured. To carry out thorough cleaning, you can
remove the cover.
Open the appliance door slightly.
1.
Press on the right and left side of the cover (fig.
2.
Remove the cover (fig.
3.
Close the appliance door carefully
Clean the stainless-steel inlay in the cover with
Note:
a stainless-steel cleaning agent. Clean the rest of the
door cover with soapy water and a soft cloth.
Open the appliance door again slightly. Put the
4.
cover back in place and press on it until it clicks
audibly into place (fig.
Close the appliance door.
5.
Removing and fitting the door panels
To facilitate cleaning, you can remove the glass panels
from the appliance door.
Removing the door panels from the appliance
Open the appliance door slightly.
1.
Press on the right and left side of the cover (fig.
2.
Remove the cover (fig.
3.
Appliance door
).
"
).
#
).
"
en
).
!
).
!
39
Advertisement
Table of Contents
